View Single Post
trajectory
 
Quote:
Originally Posted by DopefishLives View Post

Anything over 12$ a rotor is too much for turning discs. I use to be able to get them for 6$ a corner. This of course assumes you remove them from the car and bring them to the lathe operator.

What brand rotor, what brand pads? How are your wheel bearings?

Brembo rotors. Don't know what brand pads. I'm not sure about the wheel bearings, either. Keep in mind the quote is for getting them turned while they're on the car, not with a bench lathe.
__________________
25632a0b7c1c89ee24490be669336367 [y yuo throw haet :( :(] porn may <3's yuo.
Old 12-31-2009, 12:46 PM trajectory is offline  
Reply With Quote
#8